Poulan Pro 405035, Operator'S Manual

21

FIG. 27

TO LEVEL MOWER

Make sure tires are properly infl ated to the PSI shown on 
tires.   If tires are over or under infl ated, it may affect the 
appearance of your lawn and lead you to think the mower 
is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 28)
•      With all tires properly infl ated and if your lawn appears 

unevenly cut, determine which side of mower is cutting 
lower.

NOTE:

 As desired, you can raise the low side of mower or 

lower the high side.

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER 

VICE OR AD 

JUST -

MENTS:

•

Depress brake pedal fully and set parking brake.

•

Place attachment clutch  in “DISENGAGED” position.

•

Turn ignition key to “STOP” and remove key.

•

Make sure the blades and all moving parts have completely stopped.

•

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact  

 with 

plug.

TRACTOR 

(See Fig. 27)

TO REMOVE MOWER 

•      Place attachment clutch in “DIS EN GAGED” position.
•      Lower attachment lift lever to its lowest position.
•      Disengage belt tension rod (K) from lock bracket (L).

CAUTION:

 Belt tension rod is spring 

loaded. Have a tight grip on rod and re-

lease slowly.

•      Remove mower belt from electric clutch pulley (M).
•      Disconnect front link (E) from mower - remove retainer 

spring and washer.

•     Go to either side of mower and disconnect mower 

suspension arm (A) from chassis and rear lift link (C) 
from rear mower bracket (D) - remove retainer springs 
and washers. 

•      Go to other side of mower and disconnect the suspen-

sion arm and rear lift link.

CAUTION:

 After rear lift links are discon-

nected, the attachment lift lever will be 

spring loaded. Have a tight grip on lift lever 

when changing position of the lever.

•      From right side of mower, disconnect anti-sway bar (S) 

from right rear mower bracket (D) - remove retainer 
spring and washer and pull mower toward you until 
the bar falls from the hole in bracket. 

•     Turn tractor steering wheel to the left as far as it will 

go.

•      Slide mower out from under right side of tractor.

TO IN STALL MOWER

Follow procedure described in “INSTALL MOWER AND 
DRIVE BELT” in the As sem bly section of this manual. 

D

C

B

H

E

F

M

L

A

K

S