12
Adjusting the Control Cable
Checking the Control Cable
Release the control bar to remove the slack in the control
cable (Figure 20).
IMPORTANT:
The control cable must contain some slack
when you disengage the control bar for the auger blades
to stop properly.
NOTE:
You may need to adjust the control cable from
position 1 (default) to position 2 if you notice belt slip
when the control bar is engaged.
NOTE:
If the control cable is adjusted to position 2,
ensure that the auger stops properly when the control bar
is released
Inspecting the Auger Blades
Before each session, inspect the auger blades for wear.
When a auger blade edge has worn down have an
Authorized Service Dealer replace the auger blades and
the scraper (Figure 22).
Figure 22
1. Auger blades
2. Scraper
1
2
Adjusting the Control Cable
1. With the control bar disengaged, unhook and move
the control cable to the highest position. (Figure 21).
Figure 20
1. Control bar
1
1. Control bar
2. Adjuster link
3. Cable positions
Figure 21
1
2
3
Position 1: Default position
(Lower Hole as shown in illustration)
Position 2
Summary of Contents for 436414
Page 27: ...27 SERVICE NOTES...
