+-
Getting Started
Thank you for choosing the new
PowaKaddy C2i GPS
. Please read these instructions carefully. Battery care is very important,
please refer to section 13 in the back of this manual for battery care instructions.
When you receive your new PowaKaddy you will have the following:
The rear wheels are assembled and released by pressing the black release clip and pushing onto the axle until the clutch is engaged.
Note: the wheels can be locked into two positions on the axle; push onto the inner groove to engage drive. The outer groove can be
used when drive is not required. To open the frame, pull the yellow release handle (1) down and unfold the front wheel so the frame is
flat. Release the cam lock lever under the handle right side (2) and then press the release button (3) and lift the handle up to open the
upper frame. Ensure the middle joint is open fully to the stop position on this joint before closing the same cam lock lever.
1
2
1 x Trolley | 1 x Lithium Battery | 1 x Charger | 2 x Wheels | 1 x Instruction pack
IMPORTANT- you must fully charge your battery before use. Always recharge
your battery within 24 hrs of use. Failure to do so could reduce the life of your
battery. See Section 13 Battery Care.
1 2h
7h
B
C
+-
A
1
2
3
Your C2i GPS trolley will already be pre-set to run straight. If you
find your trolley is tracking to the left or right you can re-adjust this
by releasing the front wheel lever and rotating the adjustment roller.
Rotate up to make your trolley track more to the LEFT and rotate
down to track more to the RIGHT. Once you are happy the trolley is
running straight re-apply the lever to lock in position.
Front Wheel Adjustment
3
1
2
1
2
PLUG ‘n’ PLAY
™
Note: Your Lithium or Lithium Extended battery is stored in the frame for transportation. Remove the battery and
activate using the isolation button located on the underside of the battery. The green LED must be iluminated
when using the trolley and during charging. (See Section 2 Plug‘n’Play™ for battery removal)
On
Your Freeway trolley features an innovative Plug’n’Play™ battery
system including sprung terminals and a locking feature to
maintain power connection over uneven terrain. Once your
battery is charged and trolley assembled connect your battery
as shown.
•
Engage the rear of the battery first.
•
Press the front until the battery clips into position.
The trolley’s power will automatically be connected.
To remove the battery depress the front latch and lift the front of
the battery out.
Note: The Lithium battery can be stored within the tray for
transportation. Please ensure you de-activate the battery using
the isolation button located on the underside. Leaving your
battery on with the Green LED iluminated could lead to your
battery discharging or trolley activating during transportation.
