Drive, Approach and
Total Distance
Distance Units
Yards / Meters
Default Display
Understanding the Battery Gauge:
The battery gauge on the FW5s is similar to a car fuel gauge - F (full), ½ (half full) & E
(empty). There are five blue bars and depending on the charge state of your battery
will determine how many bars illuminate. When a fully charged battery is connected to
the trolley all five blue bars will illuminate.
As you progress through your round the blue bars will extinguish from full to empty.
When the fifth blue bar is extinguished it indicates that the battery is flat. When your
battery is new you may lose only one or two bars during the entire round. As your
battery ages, you may lose more bars.
If you lose all the blue bars this could indicate; (1) you have not fully charged your
battery (2) your battery is nearing the end of its useful life and you should consider
buying a replacement.
Automatic Distance Function (ADF):
The ADF function is a convenient way of sending your trolley a set distance. (15, 30, 45 yards
or meters) For example when you are approaching a green you can send the trolley towards
the next tee if the route allows. Please note it is not recommended to send your trolley
unattended over steep or rough terrain. To activate when trolley is in pause mode:
1: Press and hold the central control knob until ‘ADF’ appears on the display
2: Rotate the control knob to select the distance required between 15-45 Yrds/Metres.
3: To start the function press the control knob.
4: To cancel rotate the Central Control Knob to “00” and select by pressing the control knob.
WARNING!
Before using the ADF function please ensure the route is clear from any
obstacles. To interrupt the distance function when in operation press the on/off
button to stop the motor function.
**Please note ADF distance are approximate based on flat level terrain conditions using a fully charged battery. The overall
distance may be affected by terrain conditions, obstacles or incline, battery power and weight of golf bag5
Right Function Button
- Press to toggle between Yards and Meters.
USB Charging Port:
Located on the underside of the handle. Open the hatch to charge
GPS & mobile devices. The output is rated to 5v/500mA suitable for most USB devices*
Factory Settings
Your new FW5s trolley is ready to use, but there are a number of preferences you can
change in the programming mode. To enter programming mode:
1: Connect the battery to the trolley.
2: With the trolley powered and the default display shown press and hold both function
buttons for 3 seconds. The main features on the display will be replaced by the clock
flashing in the top left hand corner of the display.
3: Press the central control knob to select the time and then rotate to change the value.
Press the central control knob to confirm the value; and move to the next digit. Repeat the
process until the time is set as required. When complete the time will flash once again.
*USB output voltage 5v/500mA compatible with most USB portable devices, please check device manufacturers instructions
before use. Powakaddy International Ltd accepts no liability for loss of data or damage from using the charging port with
incompatible device.
Yards / Metres
ADF indicator
ADF Distance
Trip Time Indicator
Total / Trip Distance Indicator
Distance
Left Function Button
Central Control Knob
Right Function Button
Time
Digital Speed Setting
Power Indicator
Distance Measurement
Clock
Competition Mode
Battery Gauge
ON
OFF
Right Function Button
- Press to toggle between Time,Trip time and Calories.
•
Time:
The time is shown in the top left corner of the display. This displays the current time.
To adjust the time see factory settings below.
•
Trip Time:
This displays the “on” time of the trolley. This will reset when the battery is
disconnected.
•
Total Trip:
This displays the total trip distance travelled during the round. This will reset
when the battery is disconnected.
•
Calories:
This feature displays the approx. calories burned during your round of golf.
This total will be reset when the battery is removed.
USB Charging Port:
Located on the underside of the handle. Open the hatch to charge
GPS & mobile devices. The output is rated to 5v/500mA suitable for most USB devices*
*USB output voltage 5v/500mA compatible with most USB portable devices, please check device manufacturers instructions
before use. Powakaddy International Ltd accepts no liability for loss of data or damage from using the charging port with
incompatible device.
•
Approach:
Use to measure your “approach” distance. Reset your “approach”
measurement (select “approach” press and hold the left function button to reset) as you
go past the nearest Fairway Distance Marker. Walk to your ball and subtract the distance
measured from the marker distance. This will be the required distance to the green.
•
Total:
This will show the total distance covered by the trolley. This cannot be reset.
Left Function Button
- Press to toggle between distance measuring.
Drive:
Reset before leaving the tee to measure your drive*. To reset press and hold the left
function button (note this will also reset your approach).
*Please Note: The drive distance displayed is distance travelled by the trolley under power and may not represent total yards/
metres of shot where playing across water or other terrain obstacles that do not allow travel in a straight line from tee to
ball. The total distance will also be affected by freewheeling downhill and if the rear wheels slip excessively on wet or loose
ground.
Power Indicator:
Displays whether power is being applied to
the drive system. (green/red)
The FW7s with latest technology and cutting edge styling has a powerful 230w
motor and bright colour multi-function LCD display. The trolley includes distance
measuring functions, a calorie counter and USB charging port.
Digital Speed Setting:
Rotate the central control knob to adjust the speed of the trolley from 0 - 9 when
the motor is powered on. Press central control knob to pause and resume your
selected speed.
4: Press the right function button to bring up the ‘comp mode’ setting.
5: Press the central control knob to turn ‘comp mode’ on and off. Please be aware with
competition mode activated all distance measuring features will be deactivated.
6: Press and hold both function buttons to save and exit after changing any settings. The
display will then return to the default display.
At any point, press and hold both function buttons to exit the factory settings.
00937-01-08 Freeway Instruction Booklet.indd 4-5
18/01/2018 13:05:49
