Clock
Speed Setting 0-9
Speed Indicator
Power Indicator
USB
Trip Time
Trip Distance
Calories
Once a course has been selected you will be directed to the default
display which features are listed below:
Clock:
Displays the current time from the GPS information. To adjust the
time for daylight saving hours see Settings options section.
Yards/Meters:
The distance unit used for trolley distances. Change in
Settings.
Speed Setting:
Rotate the control dial to adjust the speed of the FW7s
GPS from 0 to 9. Press to pause and resume your selected speed.
Power Indicator:
When the motor is running ‘ON’ will be displayed.
When the motor is paused ‘OFF’ will be displayed alongside the flashing
speed setting.
Speed Indicator:
Speed of the trolley displayed in MPH or KMH.
(Change the speed unit in Settings)
Yards/Meters:
The units used for GPS measurements (Yards / Meters)
Press and Hold the Left Button to toggle between the following:
Total Distance:
This displays the total distance the trolley has travelled.
Trip Time:
This displays the “on” time of the trolley. This will reset when the battery
is disconnected.
Trip Distance:
This displays the total trip distance travelled during the round. This will
reset when the battery is disconnected.
Calories:
Displays the approx. calories burned during your round of golf.
This total will be reset when the battery is removed.
Yards/Metres
Automatic Distance Function (ADF):
The ADF mode is a convenient way of sending your trolley a set
distance. For example when you are approaching a green you can send
the trolley towards the next tee if the route allows. Please note it is not
recommended to send your trolley unattended over steep or rough
terrain. To activate:
•
Press and hold the central control knob until ‘ADF’ appears on the
bottom right of the display.
•
Rotate the control knob to select the distance required between
5-50 Yards/Metres.
•
To cancel the ADF mode rotate the Central Control Knob to “0” and
select by pressing the control knob.
•
To start the function press the control knob.
•
You can stop the trolley in ADF mode at any point by pressing and
releasing the on/off control, this will pause the trolley motor function.
WARNING! Before using the ADF function please ensure the route
is clear from any obstacles. To interrupt the distance function when
in operation press the on/off button to stop the motor function.
**Please note ADF distance are approximate based on flat level terrain conditions using a fully
charged battery. The overall distance may be affected by terrain conditions, obstacles or incline,
battery power and weight of golf bag.
ADF
