RoboKaddy
9
10
P R O B L E M
P O S S I B L E C A U S E
W H AT T O T RY
My RoboKaddy will not work.
My RoboKaddy stops on
the course without my
command.
My battery has failed and I
can’t push my RoboKaddy.
Machine is out of range.
Batteries are running
very low.
Have you disengaged
the wheels?
Machine not stationary
Move closer and try again.
Recharge main battery/
replace. Have the main
battery checked/replaced.
Check and follow section
on disengaging wheels in
Q and A.
Main battery flat.
Handset battery flat.
Main battery not connected.
Switching from remote
to manual.
Fully charge main battery.
Check the LED in the centre
of the handset, if flashing
red when activated all is ok.
Try RoboKaddy in manual
mode. Check battery
connections.
Turn the machine off then on
with the rocker switch and
try again.
My RoboKaddy will not go
in reverse.
The trolley must be stationary
and off or stop keys pressed
before you can select reverse.
P R O B L E M
P O S S I B L E C A U S E
W H AT T O T RY
The LED on the base
controller is displaying a
red light.
The LED on the base
controller is flashing
red light.
The LED on the base
controller is displaying an
orange light
The current overload has
been tripped.
The main battery has
fallen to below the required
voltage to operate.
The handle is communicating
correctly with the base
controller.
Avoid the obstruction or
circumstance that has
caused this. The unit will
re-set after a short while in
the idle position
If you are attempt more than
18 holes, this may sometimes
occur. If you have forgotten
to charge the battery, this
will occur. At any other time
speak with your service agent
or PowaKaddy for help.
The thermal overload has
been tripped.
Avoid the obstruction or
circumstance that has caused
this.The unit will re-set when
a safe working temperature
has been reached.
The LED on the base
controller is displaying a
flashing orange light.
No action needed.
Trimmer function requires
adjustment.
Tracking is out of
adjustment.
Air tire models, tire soft
on one side
My trolley pulls to left or right
on a flat surface.
See page 7 for trimmer
details.
See page 7 for tracking
instructions.
Ensure tires are both
between 20 - 24 psi
(1.38 -1.65 bar).
Trouble Shooting
Trouble Shooting
