Your trolley will already be pre-set to run straight. If you find your trolley tracking
to the left or right you can re-adjust this by releasing the front wheel lever and
rotating the adjustment roller. Rotate up to make your trolley track more to the
LEFT and rotate down to track more to the RIGHT. Once you are happy the trolley
is running straight re-apply the lever to lock in position.
The new PowaKaddy TOUCH is fundamentally different, intuitive and simple to use. It automatically changes pace when you change yours.
The best way to use is not to think simply Touch ‘n’ Go. Rest your hand on the comfortable soft touch handle grip, start walking and the
TOUCH will respond to your walking speed. We hope you enjoy your new TOUCH and welcome your feedback and comments. Please
read these instructions carefully. Battery care is very important, please refer to the back page of this manual for battery care instructions.
When you receive your new Powakaddy you will have the following:
1 x Trolley
|
1 x Battery (Lead-Acid or Lithium)
|
1 x Charger
|
2 x Wheels
|
1 x Instruction pack
IMPORTANT
- you must fully charge your battery for a minimum of
12 hrs before using your trolley. Always recharge your battery within
24 hrs of use. Failure to do so could reduce the life of your battery.
Note: If you have purchased a Lithium or Lithium Extended product the battery is stored in the frame.
Remove the battery and activate using the isolation switch located on the underside of the battery.
(See Section 2 Plun ‘n’ Play for battery removal)
Your TOUCH trolley features an innovative Plug’n’Play™ battery
system including sprung terminals and a locking feature to
maintain power connection over uneven terrain. Once your
battery is charged and trolley assembled connect your battery
as shown.
Engage the rear of the battery first.
Press the front until the battery clips into position. The
trolleys power will automatically be connected.
To remove the battery depress the front latch (highlighted) and
lift the battery out. The Lithium battery operates in the same way.
Note: The Lithium battery can be stored within the tray for
transportation and storage. Please ensure you de-activate the
battery using the red isolation switch located on the underside.
Leaving your battery in the ON (1) position could lead to your
battery discharging or trolley activating during transportation.
P L U G ’
n
’ P L A Y
T M
1
2
2
1
2
+
-
12h
0 1
Fit the wheels by pressing the yellow release clip and pushing onto the axle until the clutch is engaged. Note: the wheels can be
locked into two positions on the axle; push onto the inner groove to engage drive. The outer groove can be used when drive is not required.
To open the frame, slide the main lock (highlighted redbelow) forward to release the handle latch and open as shown below.
1
A
B
C
Getting Started
3
Front Wheel Adjustment
4
Controls Overview
Once your battery is connected your trolley will be ready to use. The control functions
are detailed below:
Located on the underside of the handle. Open the hatch to charge
GPS & mobile devices. The output is rated to 5v/500mA suitable for
most USB device
s*
USB Charging:
Port
With the patented Touch‘n’Go Technology, the new Powakaddy TOUCH does not have a
traditional speed dial and will automatically adjust to your walking pace while you hold the
handle.
1.
When the battery is connected the kinetic power display will flash
RED
to indicate
the trolley is powered and is in standby mode. For safety there is no motor function
when you operate the handle control system in standby mode.
2.
Press the RED isolation switch located under the handle once to activate the
TOUCH. The kinetic power display will change to a solid
RED
.
3.
Pull the handle to the fully back position.
4.
The best way to operate the TOUCH is not to think simply Touch ‘n’ Go. Rest your
hand on the comfortable soft touch handle grip, start walking and the TOUCH will
respond to your walking speed. The kinetic power display will change to
GREEN
and begin to circle in a clockwise direction.
5.
To stop the TOUCH simply stop walking. The kinetic power display will change
from circling
GREEN
to solid
RED
.
6.
After 2-3 rounds of using TOUCH you should find operating it completely intuitive
and easy to use.
*USB output voltage 5v/500mA compatible with most UBS portable devices, please check device manufacturers instructions
before use. Powakaddy International Ltd accepts no liability for loss of data or damage from using the charging port with
incompatible device. For further information see Powakaddy.com\ warranty\ terms_and_conditions\
1
2
Kinetic Power Display
Operating your TOUCH:
The unique control system of the Powakaddy TOUCH has an isolation switch to prevent
accidental use when the battery power is connected. The switch is located on the
underside of the handle.
Note: If parking your powered trolley unattended next to the club house or while loading
you golf bag it is recommended you leave the trolley in the standby mode to avoid
accidental operation.
During normal use on course the isolation switch is not required, unless leaving the trolley
unattended for long periods, the handle will hold in the stop position. Note: the stop
position is not a parking brake, the trolley drive system will still freewheel on slopes and
hills. For safety always come to a stop on flat ground or park across the slope to prevent
accidental operation or the trolley rolling unpowered.
Your PowaKaddy trolley is simple to maintain.
Never jet wash your trolley or immerse into water. Occasionally remove the wheels and apply grease to the axle and moving parts.
Your serial number can be found on the underside of the central tube under the upper bag stay. Keep a note of the serial number for reference in the
box provided above.
Maintenance
A T C H
Isolation Switch
USB Port
Solid
RED
Lights Indicate Stop
Solid
RED
Lights Indicate Stop
Pull the Handle Back to
the Stop Position Before
Pushing Forward.
Circling
GREEN
Lights Indicate Motor Powered
Push the handle forward
to increase he speed.
1
2
Serial
Number:
