Powered by Safety
®
41
Maintenance
01.4IB.60306
Table B Lubrication
Location
Reference
Figure
Lubricant
Method
Electrical Parts
Contact Block
Figure 15, r
B - Grease
Wipe clean. Apply lubricant only to actual contact surface.
Ground Connection
Figure 15, ab
B - Grease
Wipe clean. Apply lubricant only to actual contact surface.
Primary Disconnecting Device
Figure 14, a
B - Grease
Wipe clean. Apply lubricant only to actual contact surface.
Secondary Disconnect
Receptacle
Figure 14, k
B - Grease
Wipe clean. Apply lubricant only to actual contact surface.
Mechanical Parts
Camshaft Needle Bearings
Figure 15, y
C - Oil
Close Latch Shaft Face
Figure 14, n
A - Grease
Apply a light coating of grease and remove all excess.
Close Shaft Support Bearing
Figure 15, ac
C - Oil
Crank Pin
Figure 14, j
C - Oil
Flag Support Pin
Figure 15, w
C - Oil
Fundamental Linkage
Figure 15, v
C-Oil
Apply to penetrate where pins pass through lines.
Fundamental Linkage Pin
Figure 14, g
C - Oil
Apply to penetrate where pin passes through end link.
Jackshaft Lever Pins passing
through Operating Pushrods
Figure 14, m
C - Oil
Avoid lubricating on operating pushrods.
Jackshaft Outer Bearing Support
Figure 15, x
C - Oil
Jackshaft Support
Figure 14, i
C - Oil
Main Closing Spring Guide Rod
Figure 14, b
C - Oil
Motor Cutoff Cam
Figure 15, z
A - Grease
Apply to peripheral surface only.
Motor Drive Shaft Coupling
Figure 15, ad
C - Oil
Motor Drive Shaft Roller Needle
Bearings
Figure 14, o
C - Oil
Motor Drive Shaft Support
Bearings
Figure 15, aa
C - Oil
Open-Close Flag Drive Lever Pin
at Jackshaft
Figure 15, u
C - Oil
Pawl Support Arm
Figure 14, h
C - Oil
Pawls
Figure 14, p
C - Oil
Primary Trip Prop
Figure 15, t
C - Oil
Primary Trip Prop Bearing
Figure 14, e
C - Oil
Remove main closing spring.
Primary Trip Prop Roller
Figure 14, d
C - Oil
Remove main closing spring.
Racking Mechanism
Figure 15, q
C - Oil
A - Grease
Apply C - Oil to the crank arm rollers and racking crank arms.
Wipe clean. Apply A - Grease to worn gear.
Ratchet Wheel
Figure 14, l
A - Grease
Secondary Linkage Roller
Figure 15, s
C - Oil
Remove main closing spring.
Spring Yoke Pin
Figure 14, c
C - Oil
Trip Shaft Bearing
Figure 14, f
C - Oil
Wheel
Figure 15, ae
C - Oil
Note:
For all previous lubrication requirements Powlube-104 A-Grease replaces Anderol 757 and
Rheolube 368A, B-Grease replaces Mobilgrease 28 and C-Oil replaces Mobil 1 and Anderol 456.
See
Ch 5 Maintenance, B. Mechanism Area, 2) Lubrication
for more details.
