LOCATION AND FUNCTION OF CONTROLS
1.2.3. SEL( AUDIO MODE SELECT)/VOLUME UP( + )/ DN( - )BUTTONS
Press SEL button to change the mode in sequence as follows:
VOL
BAS
TRE
BAL
FAD
a. The volume can be adjusted at any time by pressing the audio level UP(+) or DN(-)
button as select mode has been initially defaulted at volume mode.
b. The volume can be also obtained by continuously pressing the SEL button until
the character VOL appear on the LCD display, then press the UP(+) or DN(-) button
to adjust the volume.
BASS CONTROL (WITHOUT EQ ACTIVATED)
a. Press SEL button to select the bass mode until BAS appears on the display.
b. Press the UP(+) or DN(-) button to adjust the bass.
TREBLE CONTROL (WITHOUT EQ ACTIVATED)
a. Press SEL button to select the treble mode until TRE appears on the display.
b. Press the UP(+) or DN(-) button to adjust the treble.
BALANCE CONTROL
a. Press SEL button to select the balance mode until BAL appears on the display.
b. Press the UP(+) or DN(-) button to adjust the left/right speaker balance.
FADER CONTROL
a. Press SEL button to select the balance mode until FAD appears on the display.
b. Press the UP(+) or DN(-) button to adjust the front/rear speaker balance.
Page 1
Page 6
+
+
+
+
FUSE 7A
YELLOW
ANTENNA PLUG
CONSTANT B+
BLACK(GND)
FRONT
REAR
RIGHT
FRONT
WHITE
WHITE/BLACK
GREEN/BLACK
VIOLET/BLACK
GRAY/BLACK
GRAY
VIOLET
GREEN
REAR
LEFT
SPEAKER
FUSE 0.5A
-
-
-
-
BLUE AUTO ANT
RED R
WHITE L
SPEAKER
FUSE 0.5A
IGNITION SWITCH
RED (B+)
RCA OUTPUT LINE
WIRING DIAGRAM
Note:
1. Make sure you use a speaker with 4 ohm load impedance to reduce
the distortion during high volume level.
2. Do not allow the antenna wire and ground (vehicle chassis)touch each other.
SPECIFICATION
GENERAL
Power requirement
DC 12V. Negative Ground
Current consumption
7A MAX.
Power output
40W x 4 MAX.
Dimensions (SET)
178[W] X 157[D] X 50[H] mm.
FM SECTION
Frequency range
88MHz -108MHz.
Usable sensitivity
10uV.
I.F Frequency
10.7MHz.
AM(MW) SECTION
Frequency range
530KHz - 1700KHz.
LINE - OUT [OPTION]
Output
2000mV @ CD MAX.
Impedance
600 ohm.
CD PLAYER
System
Compact disc audio system.
Usable disc
CD, CD-R, CD-RW disc.
Signal format
sampling frequency 44.1KHz.
Number of quantization bits 1bit.
Frequency characteristics
20Hz-100Hz < 8dB
10KHz-20KHz < 8dB.
Signal-to-Noise ratio
50dB [1KHz] [IEC - A net work].
Number of channels
2 STEREO.
PDF created with FinePrint pdfFactory trial version
http://www.pdffactory.com