UK Helpline 0905-460005 • Ireland Helpline 1520-932626
Web Support: www.heltec.eu
Model Number: PAG-125/1020
08
Safety instructions
9. Use safety glasses.
Also use face or dust mask when operation is dusty. Use ear protection.
10. Connect dust extraction equipment
If devices are provided for the connection of dust extraction and
collection facilities ensure these are connected and properly used.
11. Do not abuse cord.
Never carry tool by cord or yank it to disconnect it from electrical socket.
Keep cord from heat, oil and sharp edges.
12. Secure work.
Use clamps or a vice to hold work. It’s safer than using your hand and it
frees both hands to operate tool.
13. Do not overreach.
Keep proper footing and balance at all times.
14. Maintain tools with care.
Keep tools sharp and clean for better and safer performance. Follow
instructions for lubricating and changing accessories. Inspect tool cords
periodically and, if damaged, have repaired by authorized service facility.
Inspect extension cords periodically and replace if damaged. Keep handles
dry, clean and free from oil and grease.
15. Disconnect tools.
When not in use, before servicing and when changing accessories such as
blades, bits and cutters.
16. Remove adjusting keys and wrenches.
Form the habit of checking to see that keys and adjusting wrenches are
removed from tool before turning it on.
17. Avoid unintentional starting.
Do not carry plugged-in tools with finger on switch. Be sure switch is off
when plugging in.
18. Outdoor use extension cords.
When tool is used outdoors, use only extension cords intended for use
outdoors and so marked. Always use tool in conjunction with a residual
circuit breaker device.
19. Stay alert.
Watch what you are doing. Use common sense. Do not operate tool when
you are tired.
20. Check damaged parts.
Check the angle grinder for damaged parts before use. Check for
alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. Any
part that is damaged should be properly repaired or replaced by our
