12
Special safety precautions
Do not touch metal parts of the screwdriver during
use on masonry.
Ensure the machine is completely stopped before
changing direction.
Charging
Charge the battery fully before using the machine
for the first time.
Connect charger (8) to screwdriver charger socket
(6). Plug charger into mains electricity socket.
Allow to charge for 5-7 hours. Never charge for
more than 10 hours at a time.
Allow the screwdriver to cool after use before
recharging.
Checking battery
You can check battery strength by switching the
screwdriver on, press button (5) and check diodes (4).
ENGLISH
INSTRUCTION MANUAL
Check while machine is running.
Red/amber/green alight: Battery fully charged
Red/amber only: Battery half charged
Red only: Charge battery
Use
Insert the bit required directly into the bit holder (1).
Switch on worklight if necessary (2) by pressing
switch (3) towards illuminated bulb symbol.
Press the upper part of the on/off switch (7) for
clockwise rotation.
Press the lower part of the on/off switch for
anticlockwise rotation.
Switch off by releasing the on/off button.
Switch off worklight by pressing switch back
towards non-illuminated bulb symbol.
Cleaning and maintenance
Wipe using a well-wrung cloth after use, and
always keep the surface and ventilation holes free
of dirt.
Never use corrosive or abrasive cleaning agents,
as they may attack plastic parts.
Environmental information
You can help protect the environment!
Follow local environmental regulations:
Dispose of unwanted electrical
equipment at an approved refuse
disposal centre. Take out the battery
before scrapping the product.
