UK Helpline 0203-5142281 • Ireland Helpline 1520-932626
Web Support: www.servotool.eu
Model Number: PBS-950N
14
Wear a dust mask. Exert extra care if sanding down painted
surfaces. Some old paints may contain lead. If in doubt seek
specialist advice.
Choice of the sand-paper
Coarse sand-paper (grain 60) removes in general the bigger part of the
material and fine sand-paper is used for the finishing. If the surface is not
even, then start with rough sand-paper. Further you use middle coarse sand-
paper(grain 80) to remove the scratches left behind by the coarse sand-paper
and finally you take fine sand-paper (grain 120) for the finishing.
Operating instructions
Make sure that the machine has reached its full speed before placing the
machine on the work piece. This will prevent an overload of the machine. For
sanding wood, place the machine approximately 15° out of the grains of the
wood. Move the belt sander continuously over the work piece, in a back and
forth motion.
• Do not bend the sanding belts
• Do no use the same sanding belt for sanding wood and metal
• Do not bring too much pressure to your machine, this will only delay the
sanding.
Troubleshooting
In case the belt sander does not work well, we give you some possible causes
and solutions.
1. The electromotor gets hot
• The cool ventilation slots in the motor are blocked with dirt.
Clean the cool ventilation slots.
• The motor is defect.
Contact the address on the warranty card.
2. The connected machine does not work
• Interruption in the mains connection.
Check mains connection for fracture.
Contact the address on the warranty card.
Operation
BSM6026 Ma-GB 1104-13.indd 14
4/13/11 12:00:44 PM
