UK Helpline 02035-142281 • Ireland Helpline 1520-932626
Web Support: www.servotool.eu
Model Number: PTS-280
10
Dust collection feature
For a better dust extraction of the working surface your sanding machine can
be connected to the ordinary vacuum cleaner for house-use. You can use the
adaptor. The adaptor should installed on the rear of the machine, in the
opening.
Remember that the dust extraction only works when using perforated
sandpaper.
Before assembly sanding paper always remove the plug from the
mains.
Velcro
®
sanding paper (90 x 90 x 90 mm)
The sandpaper is fixed by Velcro
®
fastener to facilitate the replacement.
• Simply pull off the sanding paper.
• Press the new one in the centre of the sanding sole.
Coarse sand-paper (grain 60) removes in general the bigger part of the
material and fine sand-paper (grain 120) is used for the finishing.
Replacing the sanding sole
The sole has to be replaced when the Velcro
®
has been worn out.
Before replacing the sanding sole disconnect the sander from the
mains.
• Remove the sandpaper of the sole.
• Remove the screws which the sole is fixed to the sander.
• Remove the sole.
• Install the new sole on the sander.
• Tighten the screws well.
assembly
DSM6045 Ma-GB-IRE 1104-13.indd 10
4/13/11 11:49:35 AM
