Wear a dust mask. Exert extra care if sanding down painted
surfaces. Some old paints may contain lead. If in doubt seek
specialist advice.
Operation
• Push in the on/off switch (1) to start the machine.
• The ventilating apertures on the housing must remain clear to ensure
optimum cooling of the motor.
• Move the sander over the surface of your workpiece.
• Let loose the same on/off switch to stop the machine.
Prevent pushing too much on the machine during sanding. Excessive
sanding pressure does not lead to increased sanding capacity, but
increases wear of the machine and the sandpaper.
Setting the speed
The speed can be set (from slow to fast) using the continuous speed
adjustment wheel.
User tips
• Apply long uniform movements to your sander to obtain the best possible
results.
• The surface quality after sanding is determined by the selected grain.
UK Helpline 02035-142281 • Ireland Helpline 1520-932626
Web Support: www.servotool.eu
Model Number: PTS-280
11
Operation
DSM6045 Ma-GB-IRE 1104-13.indd 11
4/13/11 11:49:35 AM
