POWER ELECTRONICS
DB SERIES
SAFETY INSTRUCTIONS
9
UNPACKING
Make sure received merchandise corresponds with delivery note,
models and serial numbers.
Each equipment is supplied with a technical manual.
SEGURIDAD
Before operating the equipment, read this manual thoroughly to
gain and understanding of the unit. If any doubt exists then
please contact POWER ELECTRONICS, (902 40 20 70 / +34 96
136 65 57) or your nearest agent.
Wear safety glasses when operating the braking unit close to the
drive with power applied and the front cover is removed.
Handle the braking unit with care according to its weight.
Do not place heavy objects on the braking unit.
Install the braking unit according to the instructions within this
manual.
Ensure that the mounting orientation is correct.
Do not drop the braking unit or subject it to impact.
TRIAL RUN
Follow the steps described in this manual.
Always apply voltage and current signals to each terminal that
are within levels indicated within this manual. Otherwise, damage
to the braking unit may result.
Summary of Contents for SDRIVE DB Series
