POWER ELECTRONICS
DB SERIES
INSTALLATION OF DYNAMIC BRAKING UNIT
19
TERMINAL
DESCRIPTION
G Ground
terminal.
Connection for negative terminal of DC Bus of the drive
(DC Bus (-)).
N
Connection for B2 terminal of the dynamic braking
resistor.
B2
Connection for B1 terminal of the dynamic braking
resistor.
P / B1
Connection for positive terminal of DC Bus of the drive
(DC Bus (+)).
Control Terminals
Figure 4.2 Control terminals for dynamic braking unit – Group 2
TERMINAL
DESCRIPTION
Input signal (+) to Slave. Only connected when DB Unit
is configured as ‘Slave’.
IN+
[1]
Input signal (-) to Slave. Only connected when DB Unit
is configured as ‘Slave’.
IN-
[1]
Output signal (+) to Slave. In this case, DB Unit can be
configured as ‘Master’ or ‘Slave’.
OUT+
[1]
Output signal (-) to Slave. In this case, DB Unit can be
configured as ‘Master’ or ‘Slave’.
OUT-
[1]
Fault Output signal (Fault Relay).
30A
30A: Normally open contact (NO).
30B
30B: Normally closed contact (NC).
30C
30C: Common terminal.
[1]
Control signals IN+/- and OUT+/- are only used when multiple DB Units
are connected. See section ‘4.5.2. ‘Master / Slave’ Operation Mode’.
Summary of Contents for SDRIVE DB Series
