DB SERIES
POWER ELECTRONICS
CAUTION
Install the braking unit on a non-flammable surface. Do not place
flammable material nearby.
Otherwise, fire could occur.
Disconnect the input power if the drive or the braking unit gets
damaged.
Otherwise, it could result in a secondary accident or fire.
Do not connect the braking resistor directly to the DC terminal (P/B1,
N) of the braking unit.
Otherwise, fire could occur.
Do not touch the braking unit, drive and the resistor right after the
power is turn off.
The resistor is still hot.
Do not apply power to a damaged drive or braking unit, or to a drive
or braking unit with parts missing even if the installation is
complete.
Otherwise, fire or accident could occur.
Do not allow lint, paper, wood chips, dust, metallic chips or other
foreign matter into the braking unit.
Otherwise, fire or accident could occur.
WARNINGS
RECEPTION
Material of Power Electronics is carefully tested and perfectly
packed before leaving the factory.
In the even of transport damage, please ensure that you notify
the transport agency and POWER ELECTRONICS: 902 40 20 70
(Interna34 96 136 65 57) or your nearest agent, within
24hrs from receipt of the goods.
8
SAFETY INSTRUCTIONS
Summary of Contents for SDRIVE DB Series
