Air intake filter:
Provides clean air to the pump and must always be kept free of
debris. Check on a daily basis or before each use.
Air compressor pump:
Oil lubricated direct driven pump that compresses air which is
distributed to the tank.
Check valve:
When the pump is not in operation the valve closes to retain air
pressure inside the tank; an internal component.
Pressure relief valve:
The pressure relief valve located on the side of the pressure switch, is
designed to automatically release compressed air, when the air
compressor reaches cut-out pressure. The released air should only
escape momentarily and the valve should then close.
Tank safety valve:
Used to allow excess tank pressure to escape into the atmosphere.
This valve should only open when the tank pressure is above the
maximum rated pressure. If this occurs, the compressor will require
service.
Outlet pressure gauge:
Indicates the outgoing air pressure to the tool and is controlled by the
regulator.
Tank pressure gauge:
Indicates the reserve air pressure in the tank.
Regulator:
The air pressure coming from the air tank is controlled by the
regulator. To increase the pressure turn the knob clockwise and to
decrease the pressure turn the knob counterclockwise.
Summary of Contents for 410149
