Technical Specifications
Air pressure: 25 to 45 PSI
Paint canister volume: 2 Quarts
Recommended hose size: 3/8"
Air consumption: 2 to 5 CFM
Air inlet: 1/4" NPT
Safety Information
1. Keep work area clean. Cluttered areas invite injuries.
2. Keep children away from the work area. Do not allow them to handle
the tool.
3. Do not operate the paint spray gun while under the influence of alcohol
or medications. Read warning labels on prescriptions to determine if
your judgement or reflexes are impaired while taking drugs. If there is
any doubt, do not attempt to operate.
4. Do not spray near open flame, pilot lights, cigarettes, or any other heat
source. Solvents and coatings are highly flammable when painting or
cleaning. Industrial applications must follow OSHA requirements.
5. Read all information concerning coating products and cleaning
solvents. Chlorinated solvents such as 1-1-1 trichlorethane and
Methylene Chloride (a.k.a. methyl chloride) can chemically react with
aluminum and explode. Many paint sprayers contain aluminum. If in
doubt, contact the solvent or coating manufacturer.
6. Materials used when painting or cleaning may be harmful or fatal if
inhaled and/or swallowed. Once again, when spraying, always make
sure there is adequate ventilation. Use a mask or a respirator when
painting.
7. Check all seals before connecting to air supply. Make sure lid is fully
attached to cup, retaining ring is screwed past the first thread, air
pressure plug is tightened fully and air supply tube is firmly attached.
Never release the lid while the cup is pressurized.
8. Use eye protection. Coatings will cause eye irritation. Wear ANSI
approved chemical splash safety goggles. When cleaning, be especially
careful as solvents can be forcibly ejected from fluid and air passages.
8006577manual 4/4/06 12:28 PM Page 2
