Assembly
The paint spray gun will require assembly. If any parts are missing or
broken, notify your nearest Princess Auto location.
• Air paint assembly (1)
• Cover assembly (1)
• Canister (1)
• Hose (2)
• Repair kit
1. Connect the black fluid hose to the fluid outlet (#B-11) on the cover
centrepost (#B-10) and secure using the hose wrench as shown in
figure 1.
2. Connect the other end of the black fluid hose to the bottom of the spray
gun head and secure using the hose wrench as shown in figure 1.
3. Connect the red air hose to the air connection (#A-02) located on the
regulator assembly.
4. Connect the other end of the red air hose to the air connection located
on the bottom of the gun handle.
5. Connect the handle (#B-13) to the top of the centrepost (#B-10)
assembly by turning it clockwise. (See figure 2.)
6. Connect the air hose from the compressor to the air connection (#A-02)
and secure. An air coupler may be needed between the compressor
hose and the air connection. (See figure 3.)
7. Set the air pressure at the compressor to approximately 45 PSI.
Figure 2
Figure 3
Adjusting
Cap
8006577manual 4/4/06 12:28 PM Page 4