ASSEMBLY
UNPACKING
When unpacking, check to make sure that all parts shown in the Parts Diagram are
included. If any parts are missing or broken, please contact the seller.
4
For technical questions call: 1-800-665-8685
5. Works with any standard drill press, and is adaptable to a large variety of round cutters, hole
saws, and milling bits.
WARNING
: When using this Pipe/Tube Notcher with any powered tool, observe all safety
precautions relevant to that equipment. Refer to the owner’s manual of the power equipment
for safe practices in the use of attachments.
bolts or standard machine bolts, washers and nuts. Hardware
3. After mounting, be sure that the Spindle (7#) travels smoothly without binding against the
Bushings (5#). Any undue friction will cause excessive wear of the Bushings (5#).
4. The angle of the Pipe/Tube Notcher can be adjusted by loosening the Bolts (16#) that adjust
the Adjustable Angle Joint Plate (17#), and moving the Assembly as necessary.
5. For side to side adjustments, adjust the Bolts (15#) that hold the Adjustable Angle Joint
6. When installing the hole saw, check first to see if its arbor is 1/2” or 5/8”. The thread on the
spindle is for 1/2”, however, there is a Hole Saw Adapter (3#) for 5/8” thread that can be
screwed on over the 1/2” thread. You may need to use the Hole Saw Adapter Washer (4#) to
7. To install a saw blade or bit, first fix the Spindle (7#) in place with the Locking Pin (14#). Do
not use locking pliers or clamps to hold the Spindle (7#), as this will cause damage. Slide the
Locking Pin (14#) through the hole in the side of the Spindle Support (6#) and through the
Spindle (7#). Install the blade, then remove the Locking Pin (14#).
WARNING :
Make sure the Locking Pin (14#) is removed prior to engaging the drill.
OPERATION
1. Insert the tubing you wish to cut in the Clamp Assembly (1#), underneath the inverted “V”. The
inverted “‘V” feature of the clamp will hold your tubing (up to 2” long) in place. Do not insert the
assure a good, secure fit.
1. The Spindle (7#) is shipped in the reverse position. Remove it and re-insert it in the correct
position prior to using the tool.
2.Your Pipe/Tube Notcher must be mounted to your drill press table, using the
Depending on the configuration of your drill press table,
tubing more than half of its length. When cutting in severe angles, only insert the tubing far
Plate (17#) to the Body (13#).
Angle Joint Plate (17#).
use T-bolts, carriage
supplied.
Adjustable
you may
is not
enough to start the cut.Secure the tubing in place using the Handle/Clamp Screw Assembly(2#)
8536609
Pipe/Tube Notcher
