Power Fist 8536609, User Manual

8536609

Visit www.princessauto.com for more information 

5

Pipe/Tube Notcher

3. Use a suitable light grease on the bushings to prevent overheating and wear.

4. When cutting metal tubes, use plenty of cutting fluid to prevent tool or material overheating, and

to remove cuttings from the work area.

5. Be sure to carefully align the drill press spindle and the Pipe/Tube Notcher spindle to prevent

6. After use, clean the Pipe/Tube Notcher, and apply a light lubrication to all moving parts and

unpainted metal to prevent rust.

7. Leave the Locking Pin (14#) in place in the Spindle Support (16#) when moving or storing this

8. Store the Pipe/Tube Notcher covered and in a dry, dust free place.
9. Help avoid injury by preventing access to this tool by unauthorized persons and children.

1. Please observe good shop practices for your safety and to extend the work life of your tools.

MAINTENANCE

2. Periodically brush away cuttings and debris from the Pipe/Tube Notcher, especially the

bushings and spindle area to avoid scoring or binding these components.

binding.

fixture.

PLEASE READ THE FOLLOWING CAREFULLY

2. Set the speed of your drill press to approximately 500 rpm for most materals. When cutting thin

     wall, hard alloy tubing such as chrome-moly,higher speeds will be required.When cutting softer,

     coarser materals,slower speeds may be ideal.

     SUGGESTION:Practice on scrap materal before making cuts on your work materal.

3. As you work, lubricate both the hole saw and the bushings with cutting oil to extend service life.

4. When doing severe angle cuts with large diameter tubing,you will need to put the Spindle

Support(6#) in its uppermost position in order to accomodate its size. However, you should

always position the Spindle Support(6#) as low as possible to preserve accuracy. To move the

Spindle Support(6#) ,simply loosen the two Bolts(16#) that affix it to the Body(13#) reposition

and secure the Bolts(16#).

5. To adjust the angle of the clamp, loosen the Bolts(15#) that secure it to the Bolts(13#),proceed

     to the angle you desire according to the Angle lndicator(10#),and retighten the Bolts(15#) .

6. When the tube is clamped in the 

Pipe/Tube Notcher and the 

angle is properly set,you can proceed

     to cut the workpiece.

7. To remove the blade or bit,shut off the drill press,insert the Locking Pin(14#) into the Spindle

     Support(6#) ,and remove the bit.