V4.1
3/16 in. Air Hydraulic Riveter
8549768
Visit www.princessauto.com for more information
7
2. Screw the quick coupler into the tool's air inlet and tighten with a wrench
until snug.
3. Run compressor at a low volume and check the connection for air leaks.
Do not use the tool until all air leaks are repaired or the faulty component
is replaced.
NOSE PIECES
1. Select the appropriate sized nose piece for your task.
IMPORTANT! There are four different sizes of nosepieces that come with the
air hydraulic riveter.
2. Remove the nosepiece (#1A) by using the wrench (#36) to remove the
frame head (#11).
3. Insert the selected nosepiece into the frame head (#11) and reattach the frame
head (#11) to the frame (#15), securing tightly with the wrench (#36).
4. The hanging ring and pin cap are optional. The riveter can be used without
them. Place the housing cap o-ring (#10A) and hanging clip (#20) outside of
housing cap (#21) then turn and lock pin cap nut (#22) with pin cap (#23) put
inside on housing cap (#21). Hanging ring position can be adjusted before pin
cap nut is locked.
OPERATION
1. Tighten the frame cap nut (#22) to secure the safety cap (#23).
IMPORTANT! Position the slot of the safety cap (#22) to face upward to
avoid spilling the used rivet pins.
2. Select the appropriate size nosepiece to match the rivet’s pin used and
install following the instructions in the Nosepiece section.
IMPORTANT! When drilling holes in the work piece for the rivets, it is
important to use the same diameter of drill bit as the outer diameter of the
rivet you will be using.
3. Connect the air hose from the air compressor to the quick connector of the
air hydraulic riveter.
