8549768
3/16 in. Air Hydraulic Riveter
V4.1
8
For technical questions call 1-800-665-8685
4. Turn on the air compressor. The regulator should be set to 90 PSI.
WARNING! Do not exceed 90 PSI.
5. Insert the small end of the selected rivet fully through the nosepiece.
WARNING! Keep fingers and objects away from the trigger (#40) when
inserting rivets.
6. Insert the rivet into the predrilled hole in the workpiece.
7. With both hands, firmly grasp the riveter and squeeze the trigger (#40) to activate
the tool. If necessary, repeat the procedure of squeezing the trigger (#40).
8. Once the rivet has been fastened, release the trigger (#40).
9. Once you have finished using the air hydraulic riveter, turn off the air
compressor. Squeeze the trigger to relieve any pressure that may be caused by
compressed air still in the riveter. Disconnect the air hose from the riveter and
store the riveter in a cool, dry place, out of the reach of children.
CARE & MAINTENANCE
1. Make sure the trigger switch is in the OFF position and the air source is
removed from the tool before performing any inspection, maintenance
or cleaning.
2. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
3. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
4. Daily maintenance: Use a soft, dry cloth to remove all dirt, grease and
debris from the exterior of the tool. Do not use solvents to clean the tool.
IMPORTANT! Do not immerse the tool in liquids.
5. Follow instructions for lubricating and changing accessories.
6. Only use accessories intended for use with this tool.
7. Keep the tool handles clean, dry and free from oil/grease at all times.
8. Maintain the tool’s labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
