Visit www.princessauto.com for more information
11
8558777
V 4.1
2-in-1 Flooring Nailer and Stapler
CLEARING JAMS
Occasionally, fasteners may become jammed in
the firing mechanism of the tool, making the tool
inoperable. To remove a jammed fastener, follow the
steps below:
1.
Disconnect the tool from air source.
2.
Empty the magazine. Make sure all
fasteners are removed.
3.
Try to fire the tool into a piece of scrap
wood or flooring to make sure that it's
incapable of firing any fasteners.
4.
Lean the tool back. With the Drive
Guide(H) facing away from you, remove
the two Bolts(l). Then remove the Drive
Guide(H) to expose the jammed fastener.
5.
Removed jammed fastener, using pliers or a screwdriver if required.
6.
Replace the Drive guide(H) and Bolts(l).
7.
Reload the tool with fasteners, then, reconnect the air source to the tool.
8.
Press the Drive Guide(H) against a piece of wood, and test fire the fasteners several
times to check for proper operation. If the tool is properly firing, you may continue
using the tool. If the tool fails to perform properly, immediately discontinue use
and have the tool repaired by a qualified service technician. When finished working,
disconnect the air source.
9.
Remove fasteners. Discharge any trapped air. Then store the tool in a clean, dry, safe
location out of reach of children.
WARNING: Make sure there is no fastener in magazine before clearing a jam.
WARNING: Disconnect the tool from the air source whenever clearing a jam. After
disconnecting the tool from the air compressor, there should still be enough air pressure
to fire the tool. After the air hose is disconnected, always fire the tool into scrap wood
repeatedly to make sure all of the compressed air is expended.
Driver Guide (H)
Hex. Bolt (I)
