8717035
115V Mini Utility Pump
V1.0
10
For technical questions call 1-800-665-8685
NOTICE! NEVER use a penetrating oil to lubricate the device. Penetrating oil
may act as a solvent that can break down the grease and cause the device
to seize up.
STORAGE
Drain liquid from the system before storing. When storing for an extended
period, apply a thin coat of lubricant on the pump cavity and impeller.
DISPOSAL
Recycle a device damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the device does not
function properly or parts are missing. If unable to do so, have a qualified
technician service the device.
Problem(s)
Possible
Cause(s)
Suggested Solution(s)
Pump does not
prime or does
not retain prime
during operation.
1.
Suction lift is too high.
2.
Hose is kinked.
3.
Hose fitting is loose.
4.
Hose is leaking air.
1.
Adjust pump position.
2.
Straighten.
3.
Tighten.
4.
Repair or replace.
Pump runs but
water is not
discharged.
1.
Pump is not primed.
2.
Suction lift or discharge
height is too high.
3.
Hose is kinked.
4.
Impeller is faulty.
5.
Inlet is clogged.
1.
Prime.
2.
Adjust pump position.
3.
Straighten.
4.
Replace.
5.
Remove obstruction.
Motor runs too
hot.
1.
Voltage is incorrect.
2.
Discharge hose
diameter is too small.
3.
Impeller is faulty.
4.
Outlet is clogged.
5.
Liquid is too viscous.
6.
Motor openings are
obstructed.
1.
Ensure power source
conforms to device
requirements.
2.
Increase hose diameter to
3/4 in.
3.
Replace.
4.
Remove obstruction.
5.
Thin out liquid.
6.
Clear area around motor.
