V4.0
29 in. Fire Pit with Cooking Grill
8887424
Visit www.princessauto.com for more information
5
ASSEMBLY INSTRUCTIONS
Tools Required
•
Phillips Head Screwdriver
•
Adjustable Open-end Wrench
1.
Attach (4) legs (H) to fire bowl (F) with (12) M6 x 14 bolts (J)
2.
Insert one support ring section (G) into another and attach the support ring
assembly to leg (H) with (4) M6 x 14 bolts (J) as illustrated. Repeat the
same procedure to install the other support ring sections (G).
NOTE: Keep all bolts loose during the assembly of this step until all parts
are installed into the correct position.
3.
Secure (4) support ring sections (G) with (4) M6 x 14 bolts (J).
4.
Insert (2) the pins on table panels (E) into the fixed brackets on the fire
bowl (F) as illustrated. Connect table panels (E) with (8) M6 x 20 bolts (L)
and (8) M6 nuts (M). Attach (4) wing nuts (N) to the fixed brackets on the
fire bowl (F) as illustrated.
NOTE: The hole on the table panel (E) should be placed right upon the pole
on the fire bowl (F).
5.
Attach the lift handle (B) to cooking grid(C) with (2) M6*14bolts (J) as
illustrated. Attach the swing handle (A) to cooking grid (C) with (2) M6 x 14
(J) and (2) M6 nuts (M) as illustrated.
6.
Insert the cooking grid (C) post into the table opening.
Insert L-pin (D) into the hole on the cooking grid securing the pole.
CARE & MAINTENANCE
LIGHTING
1.
Make sure there is only a small amount of ash in the bottom of the bowl.
2.
Place a layer of dry kindling or a natural fire-starter onto the center of the
fire bowl.
3.
Place above that a layer of dry seasoned hardwood that is no more than 3/4
the length of the bowl diameter.
4.
Use a match to light kindling or fire-starter.