8904807
22 Ton Electric Kinetic Log Splitter
V4.0
12
For technical questions call 1-800-665-8685
STORAGE
Do not store the log splitter outside. Exposure to rain and ice can damage it.
Keep the log splitter in a cool, dry place that is out of direct sunlight.
REMOVAL FROM STORAGE
Lubricate the log splitter as described in the Lubrication section and then
perform all tasks in Operation Before Each Use section.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Possible Cause(s)
Suggested Solution(s)
Log splitter will
not start.
1. Power cord is not plugged in.
2. Fuse or circuit tripped.
3. Damaged power cord.
4. Burned or failed power switch.
1. Plug in saw to power source.
2. Replace fuse or reset breaker.
3. Contact Technical Support.
4. Contact Technical Support.
Log does not
split.
1. Log positioned incorrectly on
carriage.
2. Log exceeds maximum
allowable size.
3. Large knot in log.
1. Re-position log on carriage
against wedge.
2. Maximum allowable log size is
20 x 21 in.
3. Repeat splitting function with
log in place.
Ram retracts
slowly or not at
all.
1. Debris in the rack system.
2. Damaged or worn return
spring.
1. Clean and lube the rack system
periodically.
2. Inspect return spring and
replace if needed.
Drive belt noise
during start up or
while splitting.
1. Loose drive belt.
2. Worn drive belt.
3. Drive belt is wet from outdoor
use.
1. Tighten drive belt.
2. Replace drive belt.
3. Dry and clean drive belt.
