8940041
1/2 HP Non-Submersible Transfer Pump
V1.0
6
For technical questions call 1-800-665-8685
2. Do not expose the tool to rain, snow, frost or any other damp or wet
conditions. Water entering a tool will increase the risk of electric
shock. Only use in an environment that is dry and cool, with enough
clearance to allow air flow.
3. Do not disconnect the power cord in place of using the power switch.
This will prevent an accidental start-up when the power cord is
plugged into the power supply.
a.
In the event of a power failure, turn off the machine as soon as
the power is interrupted. The possibility of accidental injury could
occur if the power returns and the unit is not switched off.
4. Do not alter any parts of the tool or accessories. All parts and
accessories are designed with built-in safety features that may be
compromised if altered.
5. Make certain the power source conforms to requirements of your
equipment (see Specifications).
6. This tool is only for use on 120 V (single phase) and is equipped with a
three-prong grounded power supply cord and plug. Check with a
qualified electrician if you are in doubt as to whether the outlet is
properly grounded. If the tool should electronically malfunction or
break down, grounding provides a low resistance path to carry
electricity away from the user.
a.
Never remove the grounding prong or modify the plug in any way,
as this will render the tool unsafe.
b. Do not use any adapter plugs.
WARNING! All wiring should be performed by a qualified electrician.
POWER CORD
1.
Insert the power cord plug directly to the power supply whenever
possible. Use extension cords or surge protectors only when the tool's
power cord cannot reach a power supply from the work area.
a.
When operating a tool outside, use an outdoor extension cord
marked W-A or W. These cords are rated for outdoor use and
reduce the risk of electric shock.
b. Use in conjunction with a Ground Fault Circuit Interrupter (GFCI).
It is recommended that the GFCI should have a rated residual
current of 30 mA or less.
