V4.0
3.6V Cordless Screwdriver Gun
8972275
Visit www.princessauto.com for more information
5
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the Identification Key are included.
IDENTIFICATION KEY
A. Keyless Chuck
B. LED Battery
Indicator Light
C. Forward/Reverse Switch
D. Charging Port
E. Trigger
F. AC Adaptor
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
CHARGING THE BATTERY
1. Place on a clean dry surface within 3 ft (1 meter) of a 100 to 240VAC or 50
to 60Hz wall outlet.
2. Insert AC adaptor (F) into the charging port (D) located at the back of the unit.
3. Plug the AC adaptor into wall outlet.
4. Allow 3 to 5 hours for the battery to become fully charged.
NOTICE! Do not charge for more than 7 hours to prevent battery damage.
5. Disconnect the unit after charging. The LED battery indicator light (B)
shows the level of charge.
IMPORTANT! Check the LED battery indicator light to ensure tool has
sufficient charge.
