V1.0
16 Gauge Straight Finishing Air Nailer
8990863
Visit www.princessauto.com for more information
9
LUBRICATION
If you’re using the tool without the in-liner automatic oilier, place 2 to
6 drops of pneumatic tool oil onto the air inlet before each session
or after 2 hours of use.
When replacing O-rings and cylinders lubricate with pneumatic
tool oil.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-
laws for electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
Problem(s)
Possible Cause(s)
Suggested
Solution(s)
Air leak near
top of tool or in
trigger area
1. The O-ring in the trigger
valve is damaged.
2. The trigger valve head is
damaged.
3. The trigger valve stem, seal
or O-ring is damaged.
1. Check and replace
the O-ring.
2. Check and replace
the trigger valve
head.
3. Check and replace
the trigger valve
stem, seal or O-
ring.
Air leak near
bottom of tool
1. There are loose screws.
2. The O-rings or bumper are
damaged.
1. Tighten the screws.
2. Check and replace
the O-rings or
bumper.
Air leak
between body
and cylinder
cap
1. There are loose screws.
2. The O-rings or seals are
worn or damaged.
1. Tighten the screws.
2. Check and replace
the O-rings or
seals.
