air tool oil in the air inlet and then run the tool under no load until the
exhaust is clear.
2.
Manually add a drop or two of air tool oil into the tool’s coupler plug
before each use and after every hour of continuous use. The tool will not
work properly without lubrication and parts will wear prematurely.
3.
Avoid adding too much air tool oil as this can cause premature power loss
and eventual tool failure. A qualified technician will need to take the tool
apart and clean out the excess oil.
4.
Apply a generous amount of air tool oil to the tool before storing it for an
extended period of time (overnight, weekend, etc.). Run the tool for
approximately 30 seconds to ensure the oil is evenly distributed
throughout the tool. Store it in a clean and dry location.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Possible Cause(s)
Suggested Solution(s)
Tool runs at normal
speed, but loses
power under load.
1.
Motor parts worn.
1.
Have a qualified technician service
the tool.
2.
Replace tool or parts.
V1.0
STRAIGHT-GRIP AIR SCREWDRIVER
9007816
Page 11
www.princessauto.com / 1-800-665-8685