• Double-ended Phillips bit
• Hanging loop
IDENTIFICATION KEY
A.
Locking Chuck
B.
Air Exhaust
C.
Trigger
D.
Air Regulator
E.
Hang Ring
F.
Spindle Opening
G.
Air Screwdriver
H.
Forward/Reverse Switch
I.
Air Inlet
J.
Male Air Plug (not shown)
K.
Dual Screwdriver Bit (not shown)
ASSEMBLY & INSTALLATION
1.
Attach the hang ring to the air inlet. Spread and hold the ring apart and
insert the ends into the indents on the air inlet collar. The hang ring will
snap back into shape, holding the ends in position.
2.
Remove the protective cap when you are ready to install the air plug.
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (included) for use with your tool.
1.
Wrap the external threads of the coupler plug with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2.
Screw the coupler plug into the tool's air inlet and tighten with a wrench
until snug.
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
9007816
STRAIGHT-GRIP AIR SCREWDRIVER
V1.0
www.princessauto.com / 1-800-665-8685
Page 8