IMPORTANT! Vibration may cause failure if a quick coupler is connected
directly to the air tool. To overcome this, connect a leader hose to the
tool. A quick coupler may then be used to connect the leader hose to the
air line hose.
OPERATIONS
WARNING! Immediately release the trigger if the tool's bit becomes
stuck or jammed. The tool’s torque can twist your arm and cause an
injury. The tool may twist out of your grip and cause an injury to
yourself or a bystander.
IMPORTANT! Only use an accessory that exceeds the Speed rating (see
Specifications).
1.
Push the locking chuck's set cap away from the tool.
2.
Insert the screwdriver bit into the chuck, then release the cap to allow it
to snap back and lock the bit into position.
3.
Pull on the screwdriver bit to make sure it is locked in place.
4.
Attach the air hose from the air source to the tool's air coupler plug.
5.
Before using the tool on a workpiece, test the tool by running it at the
highest speed rating for at least 30 seconds in a safe position. Stop
immediately if there is any abnormal vibration or wobbling. Check the tool
to determine the cause.
6.
Move the forward/reverse switch on the bottom left (L) and the chuck will
rotate clockwise. Move the switch right (R) and the chuck will rotate
counterclockwise.
7.
Choose the chuck speed by aligning the numbers on the air regulator with
the arrow on the side of the tool. Setting 1 is the highest speed. Lower the
speed by selecting setting 2 or 3.
8.
Insert the screwdriver bit into the screw.
9.
Always hold the tool firmly in your hands before switching the tool ON.
The reaction to the motor’s torque may cause the tool to twist, as it
accelerates to full speed.
10. Squeeze the trigger to allow the air to flow.
11. Apply power in bursts to avoid stripping the screw head.
V1.0
STRAIGHT-GRIP AIR SCREWDRIVER
9007816
Page 9
www.princessauto.com / 1-800-665-8685