NOTICE! Do not tighten the collet nut without an accessory installed in
the collet. You will damage the collet.
Some accessories require collets of different sizes. Collet sizes are 1/16, 3/32 or
1/8 in. Ensure that the collet size matches the accessory's shaft diameter.
1.
Switch the tool OFF.
2.
Depress the shaft lock button, then slowly turn the shaft until the lock
engages and prevents further rotation.
3.
Loosen the collet nut by turning it counterclockwise. Use the small
wrench if necessary.
a.
Installing a Collet - Remove the collet nut. Pull the collet out of the
spindle and set aside. Insert the replacement collet. Thread the collet
nut back onto the spindle.
b.
Installing an Accessory - Leave the collet nut on the spindle. Pull the
accessory from the spindle and set aside. Slide the replacement
accessory's shaft into the spindle at least 3/4 of an inch into the
collet.
4.
Press and hold the shaft lock button and turn the collet nut until hand-
tight. Use the small wrench to secure.
OPERATIONS
ON/OFF BUTTON
1.
Hold the rotary tool so the accessory is not touching anything.
2.
Press the ON/OFF button to start the rotary tool. The accessory will
immediately begin spinning.
3.
Press the ON/OFF button again to turn the tool off.
SPEED CONTROL
Set the tool's speed by pushing the speed buttons (+ or -) to the appropriate
number based on the workpiece material (see Material chart). Speed increases
as higher numbers are selected.
9011438
CORDLESS ROTARY TOOL KIT, 40 PC
V1.0
www.princessauto.com / 1-800-665-8685
Page 10
