8957102
14 in. Electric Wet/Dry Concrete Saw
V4.0
16
For technical questions call 1-800-665-8685
vacuum cleaner to the dust nozzle via an elbow joint (accessory).
INSTALLING OR REMOVING THE WHEEL
To remove the wheel, depress the shaft
lock to hold the shaft stationary, then
loosen the hex bolt clockwise with the
socket wrench. To install a wheel, place
flange with its partly elevated side
facing the tool, and then place ring
before installing a wheel onto the
spindle
(shaft) and another flange with partly
elevated side facing outward. Be sure
to fully tighten the hex bolt
counterclockwise after mounting the
new wheel, or operation will be
dangerous.
OPERATION
CAUTION: Be sure to pull the tool when cutting a work piece.
•
This tool should only be used on horizontal surfaces.
•
Use this tool for straight line cutting only. Cutting curves can cause stress
cracks or fragmentation of the diamond wheel and abrasive cut-off wheel
resulting in possible injury to persons in the vicinity.
•
After operation, always switch off the tool and wait until the wheel has come
to a complete stop before putting the tool down.
•
When cutting concrete blocks, tiles or masonry materials, do not make a
cut in depth more than 60 mm (2-3/8"). When you need to cut a work piece
over 60 mm (2-3/8") up to 100 mm (4"), make more than two passes of
cuts. The depth of the most efficient cut is about 40 mm (1-9/16").
