2
7
6
6
.
.
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
6
6
.
.
1
1
G
G
e
e
n
n
e
e
r
r
a
a
l
l
I
I
n
n
f
f
o
o
r
r
m
m
a
a
t
t
i
i
o
o
n
n
6.1.1 Only qualified service technicians should make mechanical or electrical adjustments to the burner and/or
associated control equipment.
6.1.2 Preventive maintenance can usually be performed by building maintenance personnel.
6.1.3 Always follow the information provided in the Owner Operating Instructions at the end of this manual.
These should be conspicuously posted in the burner room at the time of the initial burner installation and
startup.
6.1.4 Always turn the power supply off to the burner and close manual fuel valves as appropriate for routine
maintenance.
6.1.5 Make sure that combustion and ventilation fresh air sources to the burner room remain clean and open.
6.1.6 Periodically check all electrical connections and make sure the flame safeguard control chassis is firmly
connected to its wiring base.
6.1.7 Refer to manufacturer’s product bulletins supplied with the burner for maintenance on the flame
safeguard control and other components.
6.1.8 Refer to heat exchanger manufacturer’s instructions for general inspection procedures and for specific
testing and inspection of all liquid level controls, pressure/temperature relief and other applicable items.
6.1.9 If you have any questions about the procedures listed above or questions relating to components or
devices on your unit not specifically covered in the above, contact Product Support at (620) 820-8301 for
assistance.
Summary of Contents for UCM-1000
Page 1: ......
