INTegral Line-Interactive Uninterruptible Power Supply Unit
—2kVA-T
Power Innovations
13
7
Normal LED
—Green LED that indicates that the UPS is operating normally.
4.2.1
—Basic Operations
Switch ON
—Press
and
simultaneously for three (3)
seconds until the UPS beeps twice.
Switch OFF
—Press
and
simultaneously for three (3)
seconds until the UPS beeps twice.
Mute
—When the UPS is ON and in Battery Backup mode, the UPS
will beep every four (4) seconds. Press
and
simultaneously for three (3) seconds to turn OFF the buzzer.
4.3—Information about Operations
Once the UPS is connected to the power source, the LCD display will illuminate immediately, displaying the main menu.
The Normal LED will be blinking to indicate that the inverter can be switched ON.
Start the unit by pressing
and
simultaneously for three (3) seconds until the buzzer beeps twice. The Normal
LED will illuminate that power is being provided to the load.
To turn the output OFF, press
and the
key simultaneously for three (3) seconds until the buzzer beeps twice.
The UPS will be on standby, with the LCD display illuminated and Normal LED light blinking until the AC source is
disconnected.
4.4—Navigating the Menus
Use
or
to select the menu display for the LCD. The menu selection screen will come up once the system is
connected to a power source.
Below, see diagrams of all menus. For information about selecting options with the menus, see
8.1
—Keys and
Indicators
.
Note
The menus below are based on the 220V system. For the 110V system, the menus are the same as
the 220V system, but the voltage numbers will be different.
