Front View:
Back View:
750VA / 1KVA 1.5KVA / 2KVA
Output receptacles
Rj11 surge protection
AC input
RS-232 com. port
Circuit breaker
USB com. port
Input voltage
Output voltage
AC mode indicator
Load level
Overload indicator
Battery mode indicator
Battery level
Low battery indicator
Fault indicator
Power switch
LCD panel
Product Overview
Introduction
Thank you for purchasing a Power Inspired Uninterruptible Power Supply. For further
information on this product or for support please visit www.powerinspired.com/vis-series/
Installation & Operation
NOTE:
Before installation, please inspect the unit. Be sure that nothing inside
the package is damaged.
Placement & Storage Conditions
Please place the UPS away from other units at least 20 cm to avoid interference. Do NOT
operat
check the specs for the limitations.)
6 hours
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best results,
suggest to charge the battery at least 6 hours before initial use.
The unit charges its battery while connecting to the utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the
power switch of UPS unit, then devices connected to the UPS will be protected by UPS unit.
Connect Modem/Phone/Network for Surge Protection
Connect a single modem/phone line into surge-protected “IN” outlet on the back panel of
the UPS unit. Connect from “OUT” outlet to the computer with another phone line cable.
Connect Communication Cable
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the USB/RS-232 port and the other to the communication
port of your PC. With the monitoring software installed, you can schedule UPS
shutdown/start-up and monitor UPS status through PC.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again
the power switch.
Problem
Possible Cause
Solutions
No words display on
the front panel even
though the mains is
normal.
AC input is not connected
well.
Check if the input power
connected to the mains.
AC input is connected to the
UPS output.
Plug AC input power cord to AC input
correctly.
Battery backup time is
shorter than nominal
value.
Batteries are not fully
charged.
Charge the batteries at least 6 hours
and then check the capacity again.
If the problem still persists, please
consult your dealer.
Batteries defect.
Contact your dealer to replace the
batteries.
Warning or fault icon
is shown and alarm is
continuously
sounding.
Fan is locked or not working. Check fans and notify your dealer.
The UPS is overload.
reconnecting devices, please verify
the total loads match the UPS
spec.
Low battery icon is
shown on the LCD
screen.
Low battery.
Charge the UPS at least 6 hours.
Fan is spinning but
UPS is not on battery
Input voltage out of range
and UPS in buck/boost mode
Normal Operation
Troubleshooting
1
2
3
4
5
1
4
2
5
3
4
