Removing Roots
1. Make sure the throttle is set to
fast
. The cutter wheel will accelerate to
cutting speed.
2. Swing the cutting wheel to one side, then lower it into the nearest roots that
are buried at the foot of the stump.
3. Swing the cutting wheel before each sweep until the roots are sufficiently
removed.
Cutting The Full Stump
1. Make sure the throttle is set to
fast
. The cutter wheel will accelerate to
cutting speed.
2. Direct the cutter wheel against the stump, beginning with the nearest top
corner of the stump. Steadily sweep it across the stump left and right,
cutting away a ½ inch of wood with each sweep.
3. Raise and lower the cutter wheel between sweeps by lowering and raising the
control handle.
4. Roll the machine forward and back by pushing and pulling on the control
handle. To do this, release the brake. Relock it when the machine has been
repositioned and continue cutting.
Stump Grinder
10
QVTOOLS, LLC
|
2731 CRIMSON CANTON DRIVE, LAS VEGAS, NV 89128
|
1-800-344-3371