6
POWERKING 1-800-344-3371 SUPPORT@QVTOOLS.COM
Chipper Operation
All branches should not exceed 5in (PK0915)/ 4in (PK0903) diameter. Fresh cut branches
and straw are recommended for best performance. Due to different hardness and
moisture content, the engine may struggle but will continue to chip. Proper insertion of
branches is large diameter to smaller diameter. It is best to put branches with leaves all
together. Small logs are not recommended.
Procedure
1.
Make sure chipper is on flat dry surface.
2.
Adjust exit chute to location for processed material.
3.
Refer to Kohler manual on how to start the engine.
4.
Adjust throttle to maximum RPM.
5.
Do not stand directly behind entry chute. Stand to the side of entry chute as
material may kick back.
6.
Load material from large diameter side.
7.
When machine starts to auto-feed, let go of branch.
8.
Let it completely process material before adding more.
9.
If machine does not auto-feed, you may need to slowly load the branches or use
other branches to guide it in.
Maintenance
Regular maintenance is the way to ensure the best performance and long life of your
machine. Please refer to this manual for proper maintenance procedures.
