ii
The unit must be installed on a sturdy level surface and ensure there is
adequate ventilation (at least 10cm all round). Do not put objects on top
of the unit. Do not situate the unit on a rug or other soft surface or
obstruct any air inlets or outlets. Do not install the unit near any heat
sources such as radiators, stoves or other apparatus that produce heat.
Do not locate the unit in an enclosed area such as a bookcase or in a
cabinet with insufficient ventilation. Do not stack multiple units on top of
each other.
The unit is not user serviceable and no attempts should be made to repair
or disassemble it in the event of a fault. Servicing is required if the unit
becomes damaged in any way, such as the power supply cord or plug
being damaged, liquid been spilt or objects have fallen into it, if the unit
has been exposed to rain or moisture, has been dropped or does not
operate normally.
This product complies with the European Low Voltage
(2006/95/EC) and Electromagnetic Compatibility
(2004/108/EC) Directives when installed and used in
accordance with this instruction manual.
The crossed-out wheeled bin is the European Union symbol
for indicating separate collection for electrical and electronic
equipment. This product contains electrical and electronic
equipment that should be reused, recycled or recovered and
so should not be disposed of with unsorted regular waste.
Please return the unit or contact your authorised dealer from
where the product was purchased for more information.
Plug Fitting Instructions (U.K.)
The power cord supplied with this product is factory fitted with a 13amp
mains plug fitted with a 4.0 amp slo-blo fuse. If it is necessary to change
the fuse it is important that a 4.0 amp slo-blo replacement fuse is used. If
the plug needs to be changed because it is not suitable for your socket, or
becomes damaged, it should be cut off and an appropriate plug fitted
following the wiring instructions below. The unused plug should be
disposed of safely as insertion into a 13amp socket is likely to cause an
electrical hazard. Should it be necessary to fit a 3 pin BS mains plug to
the power cord the wires should be connected as detailed below. The
colours of the wires in the mains lead of this product may not correspond
with the coloured markings identifying the terminals in your plug. Connect
them as follows:
The wire which is coloured BLUE must be connected to the terminal which
is marked with the letter ‘N’ or coloured BLACK.
