POWX1365MB
EN
Copyright © 2015 VARO
P a g e
|
6
www.varo.com
6.5
Service
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
7 SPECIFIC SAFETY WARNINGS FOR CIRCULAR SAWS
Keep hands away from cutting area and blade. Keep your second hand on auxiliary
handle or motor housing.
Do not reach underneath the workpiece.
Adjust the cutting depth to the thickness of the workpiece.
Never hold piece being cut in your hands or across your leg. Secure the workpiece to a
stable platform.
Hold power tool by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord.
When ripping always use a rip fence or straight edge guide.
Always use blades with correct size and shape (diamond versus round) of arbor holes.
Never use damaged or incorrect blade washers or bolt.
Don’t use any abrasive wheels with this machine!
Avoid overheating the blade tips during use!
This tool should always be used with the dust hose connected and attached to a suitable
vacuum cleaner/dust extractor.
8 ASSEMBLY
8.1
Setting the cutting depth (Fig .1)
NOTE: If possible we recommend that the cutting depth is set
approximately 2 mm deeper than the material thickness. This should help to
ensure you achieve a clean cut.
Unclamp the lock lever of the cutting depth setting clamp (7), set the required cutting depth on
the scale (4) and re-clamp the lock lever.
8.2
Changing a saw blade
WARNING: Incorrect positioning of the blade can permanently damage the
tool.
Ensure the tool is unplugged from the mains supply.
Press and hold the spindle lock button (16) on, release the clamping screw with plain
washer (8) by using the inner hexagon wrench (f) (turn clockwise to open). Remove the
clamping screw with plain washer (see
Fig. 2
, 3 and 4).
Set the cutting depth to the maximum. (See
“Setting the Cutting Depth” section)
Lift up the base plate (18).
Remove the saw blade.
The installation of a saw blade is done in the reverse order.
Press the spindle lock button (16) (until it engages) and tighten the clamping screw (8)
firmly.
NOTE: The arrow on the saw blade must agree with the arrow showing the
direction of rotation
(running direction shown on the device).
