POWX0479
EN
Copyright © 2019 VARO
P a g e
|
7
www.varo.com
7.4
Attaching and changing sanding tools (Fig. 3)
▪
Place the sanding tool in the centre of the sanding disc and press on. The holes in the
sanding tool must be in alignment with the extraction holes in the sanding pad.
▪
For round sanding pad only: conduct a test run to check that the sanding tool is clamped
in the centre.
7.5
Electronic speed control
7.5.1
Adjustable speed
Adjust the speed by turning the speed wheel, user can choose different speed for different
sanding surface.
7.5.2
Constant speed control
Keep the machine running at the same speed as selected. Do not overload by excessive
pressure.
7.6
Extension shaft (Fig. 4)
▪
Use the extension shaft (O) according to the intended operation for higher work surface
▪
Loosen the sleeve on the dust extraction outlet (N) of the upper shaft (J).do not remove
the sleeve from the outlet.
▪
Align the rear handle (O
1
) with the main handle and insert the sleeve (O
3
) on the extension
shaft (O) into the outlet (N) with a twist motion all the way to the stop.
▪
Adjust the length of the extension shaft (O) if necessary, pay attention to the
marking “max
1.65 m” on the extension shaft. Tighten the sleeve (N) after assembling/adjusting the
extension shaft.
7.7
Dust suction (Fig. 5)
▪
Loosen locking knob for length adjustment (N) by turning it in the direction of the unlocking
symbol on the tool handle.
▪
Insert Vacuum hose (P) into the end of the tool handle as illustrated.
▪
Tighten Locking knob for length adjustment (N) by turning it in the direction of the locking
symbol on the tool handle.
▪
Connect the Vacuum hose with the Ø 47 mm adapter directly to an industrial vacuum
cleaner (remove vacuum cleaner hose first).
▪
One may also connect vacuum hose with one of the 2 adapters to an industrial vacuum
cleaner without removing the vacuum cleaner hose.
7.8
Tool standard/airflow control (Fig. 6)
▪
Tool handle (P1) prevents the hose from damage when putting the tool aside during work
breaks.
▪
Control the airflow by sliding suction power adjustment ring (P3) over the opening in tool
connector (P2).
▪
The vacuuming power is at its lowest level when the opening is fully visible.
WARNING: Failure to use an approved dust bag in your vacuum cleaner will
increase the level of airborne dust in the work area. Prolonged exposure to
such dust may cause respiratory harm.
