POW4060
EN
Copyright © 2014 VARO
P a g e
|
6
www.varo.com
8 OPERATING INSTRUCTIONS
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball
bearings,…).
8.1
Switching On-off
Press On-off switch I/O
8.2
Speed adjusting dial
The tool speed can be infinitely adjusted between 4000min
-1
and 14000 min
-1
Higher
speed is obtained when the dial is turned in the direction of 6; lower speed is obtained
when it is turned in the direction of 1
9 WORKING WITH THE ROTATING SANDER
The entire sanding surface must rest on the workplace.
Switch on the machine and. apply moderate pressure, move it over the workpiece in
circular. Crosswise or lengthwise movements.
Use a coarse-grained disk for rough sanding and a fine-grained disk lot line sanding. The
best grain for a particular job is best ascertained by trial runs.
Important! Wear a dust mask and goggles
Protective gloves are recommended.
The sender must never be used for work on materials which contain
asbestos.
10 TECHNICAL DATA
Power rating
480W
Mains voltage
230V
Mains frequency
50Hz
Sanding Ø
125mm
No load speed
4000-14000min
-1
Safety class
II
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
79 dB(A)
Acoustic power level LwA
90 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
3.52 m/s²
K = 1.5 m/s²
