POWX0478
EN
Copyright © 2013 VARO
P a g e
|
6
www.varo.com
Maintain proper footing and balance at all times. Do not overreach. Use proper
scaffolding.
Always wear appropriate safety equipment when operating.
Important: after completing sanding, switch off the switch and wait for the coasting sanding
head to stop completely before putting the tool down.
Never operate the tool in an area with flammable solids, liquids, or gases. Sparks from the
commutator
/ carbon brushes could cause a fire or explosion.
There are certain applications for which this tool was designed. The manufacturer strongly
recommends that this tool can not be modified and / or used for any application other than
for which it was designed.
Use the machine with both hands at all times. Loss of control can cause personal injury.
Keep power supply cord clear from the working range of the machine. Always lead the
cable away behind you.
Immediately switch off the machine if unusual vibrations or if other malfunctions occur.
Check the machine in order to find out the cause.
The dust that arises when working with this tool can be harmful to health. Use a dust
absorption system and wear a suitable dust protection mask and remove deposited dust
with a vacuum cleaner.
6.1
Electrical connection
The network voltage must conform to the voltage indicated on the tool name plate. Under
no circumstances should the tool be used when the power supply cable is damaged. A
damaged cable must be replaced immediately by an authorized Customer Service Centre.
Do not try to repair the damaged cable yourself. The use of damaged power cables can
lead to an electric shock.
7 ASSEMBLY
7.1
Unpacking
Carefully remove the tool and all loose items from the shipping container.
Retain all packing materials until after you have inspected and satisfactorily operated the
machine.
Before setting up, repair or maintenance of the appliance you must always
turn off the operating switch and pull out the mains plug!
7.2
Before initial operation
Check if the rated frequency of the mains supply corresponds to the details of the type
place.
Before using the tool, read the instruction book carefully.
8 OPERATION
8.1
How to operate
Insert the hose into the dust access of the machine. (Fig. 1)
Tighten the side handle by turning it (Fig. 2)
8.2
Electronic control
This machine has the characteristics as below:
Lock-on switch (5)
Adjustable Speed (4)
