POWX354
EN
Copyright © 2021 VARO
P a g e
|
5
www.varo.com
▪
THINNING - Always read the paint manufacturers thinning recommendations or
instructions before using paint or other materials.
▪
DISCONNECT FROM THE MAINS SUPPLY - Always disconnect from the mains supply
when filling the paint container or cleaning the spray gun.
▪
SWITCH OFF WHEN NOT SPRAYING
– Avoid running the unit with the flow rate knob
fully closed for any length of time.
We accept no responsibility for damage caused by the use of unsuitable
substances, or paints that have not been thinned correctly, and any health
hazards that arise from lack of adequate ventilation.
5.1
Immediately switch off the spray gun when:
▪
Interruption in the mains plug, mains lead or mains lead damage.
▪
Defect switch.
▪
Smoke or stench of scorched isolation.
5.2
Coating materials suitable for use
Water- and solvent-based paints, finishes, primers, 2-component paints, clear finishes,
automotive finishes, staining sealers and wood sealer-preservatives.
5.3
Coating materials not suitable for use
Wall paints (emulsion paints) etc., alkali and acidic paints. Coating materials with a flash point
below 21 °C.
5.4
Preparation of the coating material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted.
▪
Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes
undiluted
Wood preservatives, mordants, oils, disinfection
agents, plant protective agents
undiluted
Paints containing solvents and water-soluble
paints, primers, vehicle coating paints,
hick-flm glazes
dilute by 5 - 10%
▪
If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
6 START-UP
6.1
Thinning
Always remember to disconnect from the mains supply before filling the
paint container with sprayable material.
Most paints are supplied ready for brush application and will need to be thinned before they
are suitable to be sprayed. Foll
ow the manufacturer’s advice on thinning. The paint when
used with a spray gun. The viscosity cup will help you to determine the correct viscosity of
paint to be used. To determine the correct viscosity, fill the cup to the brim with the paint.
Measure the amount of time it takes for the cup to empty back into the can.
The table below shows recommended times for different types of material.
