POWX354
EN
Copyright © 2021 VARO
P a g e
|
6
www.varo.com
If the paint takes longer than the recommended time to empty, then further thinning is required.
Mix in a small quantity of the appropriate thinner and use the viscosity test until the correct
thickness is achieved. Some sprayable materials contain particles and lumps. These materials
should be strained before filling the paint container.
Before connecting to the mains supply, be sure that the supply voltage is identical with the
value given on the rating plate.
▪
Unscrew the container from the spray gun.
▪
Aligning suction tube (Fig. 2).
If the suction tube is positioned correctly, the container contents can be sprayed without
almost any residue.
When working on lying objects: Turn the suction tube forwards (Fig. 2 A).
Spraying work when working on overhead objects: Turn the suction tube rearwards (Fig. 2 B).
▪
Set the container on a sheet of paper, pour in the prepared coating material and screw the
container tightly onto the spray gun.
▪
Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!
▪
Adjust the spray setting on the spray gun.
Three different spray jet settings can be chosen on the spray gun, depending on the
application and target object.
Selecting the Spray Setting
Fig. 3 A = horizontal fat jet
Fig. 3 B = circular jet
Fig. 3 C = vertical fat jet
The spray pattern indication can be found on the front part of the sprayer (Fig.3D, A). With the
arrowhead towards the boss on the tip (Fig.3D, B).
6.2
Adjusting the desired Spray Setting (Fig. 4)
With the union nut (2) slightly unscrewed, turn the air cap (1) to the desired spray setting
position. Then tighten the union nut.
WARNING! Danger of injury! Never pull the trigger guard while adjusting the
air cap.
6.3
Adjusting the Material Volume (Fig. 5)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
-
turn to downside
lower material volume.
+
turn to upside
higher material volume.
Viscosity Table
Spray material
Runout Time in Seconds
Oil enamel
25-45
Oil based primer
30-50
Varnish
20-55
Lacquer / lacquer sanding sealer
25-40
Oil stain
No thinning required
Clear sealer
No thinning required
Polyurethane
No thinning required
