1. Connect the red fuse holder ring terminal to the main
battery cut-off switch and the black ring terminal to the
negative post on the cranking battery. The LED light on the
top of the HPU should begin flashing green.
2. In the deployed and stored positions, keep the UP and
DOWN button pressed for 10 seconds in order to bleed all
residual air from hydraulic tubing. (
FIG. 15
)
NOTE:
The HPU will have a high pitch whining sound while
priming until air has dissipated from hydraulic fluid.
3. The HPU’s hydraulic fluid level may need to be topped-off
after the final priming has been completed.
NOTE:
Each anchor is preprogrammed as a single unit. When using only one
anchor do not program as a port or starboard.
1. Determine which HPU controls the starboard side Power-Pole anchor using
the UP & DOWN buttons on both HPUs. (
FIG. 16
)
2. Locate the PROGRAM button on the top of the starboard HPU. Depress and
hold it for 6 seconds until the LED flashes red and 2 chimes are heard followed
by a single beep. (
FIG. 17
)
3. Next, depress and release the UP button. The LED will flash red 1 time with a single
beep indicating that the HPU has been assigned as the starboard side unit. Press
and release the PROGRAM button to save and exit. The LED will flash
red 1 time with a single beep followed by 2 consecutive beeps.
4. On the port side HPU, repeat Step 2 to enter programming mode. Next, depress
and release the DOWN button on the HPU. The LED will flash red twice with
2 consecutive beeps indicating that the programming has been completed
successfully and the HPU has been assigned as the port side unit. Press and
release the PROGRAM button to save and exit. The LED will flash red 2 times
with a double beep followed by 2 consecutive beeps.
NOTE:
For additional menu settings please refer to the Owner Guide.
Program Button
Down Button
LED Light
Up Button
Figure 15
STEP
6
STEP
7
Priming The HPU
Programming Dual Units
Figure 16
Figure 17
LED Light
Program Button
Summary of Contents for Blade
Page 1: ...INSTALLATION MANUAL ...
