7
for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other
condition that may affect its operation. A guard or other part that is damaged should be properly repaired
or replaced by an authorized service center unless indicated elsewhere in this manual.
For EDGER-TRIMMERS
Keep guards in place and in working order.
Keep blades sharp.
BATTERY TOOL USE AND CARE
WARNING:
USE ONLY POWERSMART APPROVED REPLACEMENT BATTERIES,
OTHER BATTERIES MAY CAUSE INJURY OR DAMAGE TO THE MOWER. Use with
POWERSMART 40V battery.
Battery safety rules
Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in operating
condition. Be aware of possible hazards when not using your battery tool or when changing accessories.
Following this rule will reduce the risk of electric shock, fire, or serious personal injury.
Do not place battery tools or their batteries near fire or heat. This will reduce the risk of explosion and
injury.
Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has been dropped or
received a sharp blow. A damaged battery is subject to explosion. Properly dispose of a dropped or
damaged battery immediately.
Batteries can explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of
serious personal injury, never use any cordless product in the presence of open flame. An exploded
battery can propel debris and chemicals. If exposed, flush with water immediately. Do not charge battery
tool in a damp or wet location. Following this rule will reduce the risk of electric shock.
For best results, your battery tool should be charged in a location where the temperature is more than 45°F
but less than 104°F. To reduce the risk of serious personal injury, do not store outside or in vehicles.
Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact
with your skin, wash immediately with soap and water. If liquid gets into your eyes, flush them with clean
water for at least 10 minutes, then seek immediate medical attention. Following this rule will reduce the
risk of serious personal injury.
When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails,
screws, or other small metal objects that can make a connection from one terminal to another. Shorting
the battery terminals together may cause sparks, burns, or a fire.
Always remove battery pack from your tool when you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause
serious personal injury.
Always remove battery pack before storing the device. When battery becomes fully charged, unplug the
charger from the power supply and remove the battery pack from the charger.
Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing
protection. Failure to do so could result in objects being thrown into your eyes and other possible serious
injuries.
Keep battery pack dry, clean, and free from oil and grease. Always use a clean cloth when cleaning.
Never use brake fluids, gasoline, petroleum-based products, or any solvents to clean battery pack.
Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes
or skin. It may be toxic if swallowed.
WARNING: Read all safety warnings and instructions. Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious injury.
a) Prevent unintentional starting. Ensure the switch is in the off-position before connecting to battery pack,
picking up or carrying the appliance. Carrying the appliance with your finger on the switch or energizing
appliance that have the switch on invites accidents.
Summary of Contents for DB2603
Page 2: ......
Page 20: ...20 EXPLODED VIEW PART LIST ...
Page 41: ...41 VUE ÉCLATÉE ...
Page 63: ...63 DESPIECE Y LISTA DE PIEZAS ...
